Dlp- G246 Change External Controls Using The Aic-I Card - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Change DWDM Card Settings
Step 2 Double-click the AIC-I card to display it in card view.
Click the Provisioning > External Alarms tabs.
Step 3
Modify any of the following fields for each external device wired to the ONS 15454 backplane. For
Step 4
definitions of these fields, see the
Interface Controller-International Card" procedure on page
•
•
•
•
•
•
To provision additional devices, complete Step
Step 5
Click Apply.
Step 6
Return to your originating procedure (NTP).
Step 7
DLP-G246 Change External Controls Using the AIC-I Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The task is the same if you are using the AEP. In this case, the number of contacts that are shown on the
Note
screen is changed accordingly.
Verify the external control relays to the ENVIR ALARMS OUT backplane pins. See the
Step 1
Install Alarm Wires on the MIC-A/P (ETSI Only)" task on page 1-48
Wires on the Backplane (ANSI Only)" task on page 1-53
In node view, double-click the AIC-I card to display it in card view.
Step 2
On the External Controls subtab, modify any of the following fields for each external control wired to
Step 3
the ONS 15454 backplane. For definitions of these fields, see the
and Controls on the Alarm Interface Controller-International Card" procedure on page
•
•
•
•
To provision additional controls, complete
Step 4
September 2005
Enabled
Alarm Type
Severity
Virtual Wire
Raised When
Description
This task changes external control settings on the AIC-I card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Enabled
Trigger Type
Control Type
Description
DLP-G246 Change External Controls Using the AIC-I Card
"NTP-G72 Provision External Alarms and Controls on the Alarm
4 for each additional device.
(ANSI) for more information.
Step 3 for each additional device.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
8-32.
(ETSI) or "DLP-G23 Install Alarm
"NTP-G72 Provision External Alarms
"DLP-G20
8-32.
11-43