Ntp- G5 Remove The Backplane Covers (Ansi Only) - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G5 Remove the Backplane Covers (ANSI Only)
NTP-G5 Remove the Backplane Covers (ANSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
DLP-G13 Remove the Lower Backplane Cover
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Unscrew the five retaining screws that hold the cover in place
Step 1
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
1-26
This procedure describes how to access the ONS 15454 ANSI backplane
by removing the covers. The backplane has two sheet metal covers (one
on either side) and a lower backplane cover at the bottom.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-G2 Install the Shelf Assembly, page 1-8
NTP-G3 Open and Remove the Front Door, page 1-20
Required
Onsite
None
"DLP-G13 Remove the Lower Backplane Cover" task on page
"DLP-G14 Remove the Backplane Sheet Metal Cover" task on page
"NTP-G7 Install the Power and Ground" procedure on page
This task removes the lower backplane cover of the ONS 15454 ANSI shelf
assembly.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Required
Onsite
None
Chapter 1 Install the Shelf and Common Control Cards
1-26.
1-30.
(Figure 1-11).
1-27.
August 2005