Table 5-17 Mxp_2.5G_10G Or Mxp_2.5G_10E Muxponder Card Line Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
Table 5-17 MXP_2.5G_10G or MXP_2.5G_10E Muxponder Card Line Settings (continued)
Parameter Description
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary State-Primary
State Qualifier, Secondary State. For more
information about service states, see
"DWDM Administrative and Service States."
ALS Mode Sets the ALS function mode. The DWDM
transmitter supports ALS according to
ITU-T G.644 (06/99). ALS can be disabled or can
be set for one of three mode options.
SF BER Sets the signal fail bit error rate.
SD BER Sets the signal degrade bit error rate.
AINS Soak Sets the automatic in-service soak period.
Double-click the time and use the up and down
arrows to change settings.
Type Sets the optical transport type.
ProvidesSync Sets the ProvidesSync card parameter. If checked,
the card is provisioned as an NE timing reference.
(This parameter does not appear for the
MXP_2.5G_10E trunk port.)
September 2005
DLP-G223 Change Line Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Options
• IS-NR (ANSI) or Unlocked-enabled (ETSI)
• OOS-AU,AINS (ANSI) or Unlocked-disabled,
automaticInService (ETSI)
• OOS-MA,DSBLD (ANSI) or
Appendix C,
Locked-enabled,disabled (ETSI)
OOS-MA,MT (ANSI) or
•
Locked-enabled,maintenance (ETSI)
Disable (default): ALS is off; the laser is not
•
automatically shut down when traffic outages
(LOS) occur.
Auto Restart: ALS is on; the laser automatically
•
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
Manual Restart: ALS is on; the laser automatically
•
shuts down when traffic outages (LOS) occur.
However, the laser must be manually restarted
when conditions that caused the outage are
resolved.
• Manual Restart for Test: Manually restarts the
laser for testing.
1E-3
•
1E-4
•
1E-5
•
• 1E-5
• 1E-6
1E-7
•
1E-8
•
1E-9
•
Duration of valid input signal, in hh.mm format,
•
after which the card becomes in service (IS)
automatically
0 to 48 hours, 15-minute increments
•
SONET
•
SDH
•
Checked or unchecked
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-35