Figure 3-6 Positioning The Power And Ground Terminals To Accept Wires; Figure 4-6 Positioning The Power And Ground Terminals To Accept Wires - Cisco 6260 Installation Manual

Chapter 3 Installing a Cisco 6260 with a POTS Splitter Configuration
Figure 3-6
Insert the end of the grounding wire into the grounding receptacle, which is the bottom receptacle in the
Step 5
terminal block on the PEM (see
terminal block so that no bare wire is exposed.
Ensure that no wire strands are left outside the connector.
Step 6
OL-2365-02
Positioning the Power and Ground Terminals to Accept Wires
O K
U T
I N P
A I L
T F
Y 1
O U
R A
N T
Y 2
F A
R A
N T
F A
Correct
terminal
position
(open)
O K
U T
I N P
A I L
T F
Y 1
O U
R A
N T
Y 2
F A
R A
N T
F A
Incorrect
terminal
position
(closed)
Figure 3-7). The stripped part of the wire must be fully inserted into the
Cisco 6260 Hardware Installation Guide
Installation Procedures
3-11