SROS Command Line Interface Reference Guide
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Functional Notes
Use the ip rip receive version command to specify a RIP version that overrides the version (in the
Router RIP) configuration. See
The SROS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the tunnel interface to accept only RIP version 2 packets:
ProCurve(config)#interface tunnel 1
ProCurve(config-tunnel 1)#ip rip receive version 2
5991-2114
Only accept received RIP version 1 packets on the interface.
Only accept received RIP version 2 packets on the interface.
version [1 l 2]
on page 1390 for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Tunnel Configuration Command Set
1187