SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 104

Reassembly
1. Install the cylinder head with the steel gasket.
Notice
Make sure to place the "TOP" mark upward.
2. Tighten the cylinder head bolts to specified torque and
torque angle.
Tightening torque
Notice
• Apply the oil on the bolt thread when installing.
• Always insert new washer first.
• The bolts (12) at vacuum pump side are shorter than
others.
3. Install the HLA device and finger follower. Check the HLA
device with the diagnosis procedures before installation.
Notice
• Put the cylinder head on the locating pins.
4. Tighten the camshaft bearing cap bolts.
• Intake: #2, #4, #5
• Exhaust: #8, #10, #11
ENGINE HOUSING
DI ENG SM - 2004.4
Step 1 20 ± 2.0 Nm
Step 2 85 ± 5.0 Nm
Step 3 270° (90° x 3) + 10°
DI02-9
Y220_02020
Y220_02021
Y220_02022
Y220_02023
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN