42. Remove the flywheel and the crankshaft strainer.
Installation Notice
Tightening torque
43. Unscrew the bolts and remove the crankshaft bearing
caps.
Installation Notice
Tightening torque
Notice
• Remove the bearing cap bolts from inside to outside
with a pair.
• Do not mix up the crankshaft bearing caps and
shells.
Note
• Install in the reverse order of removal.
• Tighten the fasteners with the specified tightening torques.
• Replace the gaskets and bearings with new ones.
• Make sure to install the gaskets in correct direction.
ENGINE ASSEMBLY
DI ENG SM - 2004.4
45 ± 5.0 Nm,
90° + 10°
55 ± 5.0 Nm,
90° + 10°
DI01-61
Y220_01140
Y220_01141
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN