Cylinder Head Parting Surface Check - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

Cylinder Head Parting Surface Check

Specifications
Height "A" (cylinder head parting surface - cylinder head cover parting surface)
Minimum height after machining
Permissible unevenness of parting surface
Permissible variation of parallelism of top parting surface to bottom in longitu-
dinal direction
Peak-to-valley height
Valve recess "a"
Measurement
1. Measure the cylinder head height "A".
Limit
Notice
If the height is less than the limit, the cylinder head
must be replaced.
2. Insert the valves into the valve guides and measure the
recesses.
Valve recess "a"
Notice
If the measured value is out of the specified range,
machine the valve seat as much as necessary until
the specified value is achieved.
ENGINE HOUSING
DI ENG SM - 2004.4
in longitudinal direction
in transverse direction
Intake valve
Exhaust valve
Over 142.4 mm
0.1 ~ 0.7 mm
DI02-5
142.9 ~ 143.1 mm
142.4 mm
0.08 mm
0.0 mm
within 0.1 mm
0.004 mm
0.1 ~ 0.7 mm
0.1 ~ 0.7 mm
Y220_02005
Y220_02006
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN