SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 92

32. Measure the piston protrusion from the parting surface.
• Specified Value: 0.765 ~ 1.055 mm
33. Remove the cylinder head gasket.
Installation Notice
• Replace the cylinder head gasket with new one.
Make sure to place the "TOP" mark upward.
1. Put the steel gasket on the cylinder block and
position the cylinder head.
2. Tighten the cylinder head bolts to specified torque
and torque angle.
Tightening torque
• Apply the oil on the bolt thread when installing.
• Always insert new washer first.
• The bolts (12) at vacuum pump side are shorter
than others.
34. Turn over the engine and remove the baffle plate.
Installation Notice
Tightening torque
ENGINE ASSEMBLY
DI ENG SM - 2004.4
Step 1 20 ± 2.0 Nm
Step 2 85 ± 5.0 Nm
Step 3 90 ± (3 times) + 10°
10 ± 1.0 Nm
DI01-57
Y220_01124
Y220_01125
Y220_01126
Y220_01127
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN