SSANGYONG 2004 Rexton 2.7XDi Workshop Manual page 168

DI03-20
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
14. Remove the intake manifold mounting bolts.
Notice
1. Check the length of the bolts before installation.
M8 x 45: 6EA
M8 x 130: 6EA
Tightening torque
Y220_03040
15. Lift up the vehicle and remove the propeller shaft joint
bolts.
16. Unscrew the bolt in oil filter and remove the intake
manifold and gasket.
Notice
• Replace the gasket with new one.
• Make sure that the residual coolant in intake
manifold gets into the inside of inlet port.
17. Install in the reverse order of removal.
Y220_03041
Notice
• Replace the gasket with new one.
• If replaced only gasket without any other service
operation, completely remove the coolant and other
contaminants from the engine before installation.
25 ± 2.5 Nm
INTAKE SYSTEM
DI ENG SM - 2004.4