Crankshaft - Reassembly - SSANGYONG 2004 Rexton 2.7XDi Workshop Manual

DI02-40
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN

Crankshaft - Reassembly

1. Thoroughly clean the oil galleries and check the journal
section and bearings. Replace if necessary.
Y220_02106
2. Coat the upper thrust washers with oil and insert into the
crankcase so that the oil grooves are facing the crank
webs (arrow).
3. Coat the lower thrust washers with oil and insert into the
crankcase so that the oil grooves are facing the crank
webs (arrow).
Notice
The retaining lugs should be positioned in the grooves
(arrow).
Y220_02107
Notice
If the maximum permissible length of L= 63.8 mm is
exceeded, the 12-sided stretch bolts should be
replaced.
Y220_02108
4. Coat the new crankshaft with engine oil and place it on
the crankcase.
5. Install the crankshaft bearing caps according to the
markings and tighten the bolts.
Tightening torque
Notice
Install from #1 cap.
Y220_02109
55 ± 5 Nm + 90° + 10°
ENGINE HOUSING
DI ENG SM - 2004.4