Dcc Page - Osi Ulc Report - Alcatel-Lucent 1850 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
– N (Internet Protocol is disabled on the addressed DCC)
– Y (Internet Protocol is enabled on the addressed DCC)
DCC Mode - Specifies the DCC mode. The default value is TERMINATED.
•
Channel used by - The default value is MNGPLANE
•
The panel has the Save hyperlinks which closes the page and goes back to the previous
page.
The panel shows the Create link to configure a DCC Channel. See
(p. 5-42).
OSI ULC report
It allows to modify OSI upper layers stack parameters which are common to all the stack
interfaces of the NE (i. e., all the Line and Section DCC interfaces and the Customer
LAN).
Select Xcom -> DCC -> OSI ULC Report option as shown in
Figure 3-46 DCC page - OSI ULC report
The OSI Routing Configuration tab displays the OSI UPPER LAYERS
•
COMMON PARAMETERS panel that contains the following parameters:
L3ISLEVEL - This is the IS level provisioning. The values are:
•
– 1 - It is a Level 1 IS
– 2 - It is a Level 2 IS
The Save hyperlinks closes the page and return back to the previous page.
XC overhead
The menu contains the following information as shown in
............................................................................................................................................................................................................................................................
8DG08763KAAA
Issue 1 February 2009
"Create DCC Channel"
Figure 3-46.
Figure 3-47.
Xcom menu
3 - 5 3