Renault Laguna III Manual page 2641

Compressor - condenser connecting pipe: Removal - Refitting
V4Y or V9X
Equipment required
refrigerant charging station
Tightening torquesm
« compressor
condenser » connect-
ing pipe bracket nut on
the compressor
« compressor
condenser » connect-
ing pipe bracket nut on
the condenser
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair (see 62A, Air conditioning, Air condition-
ing: Precautions for the repair, page 62A-1) .
Note:
Use blanking plugs for the fuel circuits with part
numbers 77 01 208 229 or 77 01 476 857 to plug
any openings exposed to the open air. The y must
be clean. Do not use any which have already been
used to plug a fuel circuit.
WARNING
To prevent moisture from entering the system,
place plugs on the cold loop components which are
open to the air.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
WARNING
Consult the device's operating manual to avoid
incorrect use.
AIR CONDITIONING
- 8 N.m
- 8 N.m
a Drain the coolant circuit refrigerant charging sta-
tion (see 62A, Air conditioning, Refrigerant cir-
cuit: Draining - Filling, page 62A-7) .
a Remove the engine undertray.
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
- the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
- the right-hand headlight (see Headlight: Removal
- Refitting) (80B, Headlights).
a Unclip the front right-hand air deflector (1) .
62A-85
62A
134208