Quanta Computer QuantaMesh User Manual page 98

UANTA COMPUTER INC.
5.2.3.21 switchport tagging
This command configures the tagging behavior for a specific interface in a VLAN to enable. If tagging is
enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as untagged
frames. The ID is a valid VLAN identification number.
Syntax
switchport tagging <vlan-list>
no switchport tagging <vlan-list>
<vlan-list> - VLAN ID (Range: 1 – 4093) – separate non-consecutive IDs with ',' and no spaces and
no zeros in between the range; Use '-' for range.
no - This command configures the tagging behavior for a specific interface in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
Default Setting
Disabled
Command Mode
Interface Config
This command configures the tagging behavior for all interfaces in a VLAN to be enabled. If tagging is
enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is transmitted as untagged
frames. The ID is a valid VLAN identification number.
Syntax
switchport tagging all <vlan-id>
<vlan-id> - VLAN ID (Range: 1 – 4093).
all - All interfaces
no - This command configures the tagging behavior for all interfaces in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification
number.
Default Setting
Disabled
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 98