Quanta Computer QuantaMesh User Manual page 473

UANTA COMPUTER INC.
5.16.1.25 clear ipv6 neighbors
This command will use to clear all entries IPv6 neighbor table or an entry on a specific interface. Use the
<slot/port> parameter to specify the interface.
Syntax
clear ipv6 neighbors [{<slot/port> | vlan <vlan-id>]
<slot/port> - Specify the interface.
<vlan-id> - Specifies the VLAN interface. The range of the VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec
5.16.1.26 clear ipv6 statistics
This command will use to clear IPv6 statistics for all interfaces or for a specific interface, including
loopback and tunnel interfaces. IPv6 statistics display in the output of the show ipv6 traffic command. If
you do not specify an interface, the counters for all IPv6 traffic statistics reset to zero.
Syntax
clear ipv6 statistics [{<slot/port> | loopback <loopback-id> | tunnel <tunnel-id> | vlan <vlan-id>}]
<slot/port> - Specify the interface.
<loopback-id > - Specify loopback Interface ID. Range 0 -7.
<tunnel-id > - Specify the Tunnel ID. Range 0 -7.
<vlan-id> - Specifies the VLAN interface. The range of the VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 473