Quanta Computer QuantaMesh User Manual page 782

UANTA COMPUTER INC.
6.11.1.4 show ip bgp community
This command display routes that belong to specified BGP communities.
Syntax
show ip bgp community <community-number> [exact-match | local-as | no-advertise | no-export]
< community-number > - Valid value is a community number in the range from 1 to 4294967200, or
AA:NN (autonomous system-community number/2-byte number).
exact-match - Display only routes that have an exact match.
local-as - Display only routes that are not sent outside of the local AS.
no-advertise - Display only routes that are not advertised to any peer.
no-export - Display only routes that are not exported outside of the local AS.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
BGP table version: The BGP Table Version is the main number used. This number is the same as
the Generation ID of any BGP prefix for a specific address family and is used to track changes to the
BGP route table.
Local Route ID: A 32-bit integer in dotted decimal format identifying the router, about which
information is displayed. This is a configured value.
Status Codes: Status of the table entry. The status is displayed at the beginning of each line in the
table. It can be one of the following values:
•
s — The table entry is suppressed.
•
* — The table entry is valid.
•
> — The table entry is the best entry to use for that network.
•
I — The table entry was learned via an internal BGP (iBGP) session.
Origin codes: Origin of the entry. The origin code is placed at the end of each line in the table. It can
be one of the following values:
•
i — Entry originated from an Interior Gateway Protocol (IGP) and was advertised with a
network router configuration command.
•
e — Entry originated from an Exterior Gateway Protocol (EGP).
•
? — Origin of the path is not clear. Usually, this is a router that is redistributed into BGP from
an IGP.
Network: IP address of a network entity.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 782