Quanta Computer QuantaMesh User Manual page 196

UANTA COMPUTER INC.
5.2.16.2 port-mode
Use this command to configure a 40G QSFP port in either 4x10G mode or 1x40G mode. After the mode
is changed, it will not take effect immediately until the next boot cycle.
Syntax
port-mode {1x40g | 4x10g}
1x40g – Configure the port as a single 40G port using four lanes.
4x10g – Configure the port as a four 10G ports, each on a separate lane. This mode requires the
use of a suitable 4x10G to 1x40G pigtail cable..
no - This command resets to the default value. The default value is 1x40g.
Command Mode
Interface Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 196