Control Plane Protection Commands; Show Commands; Configuration Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.29 Control Plane Protection Commands

5.29.1 Show Commands

5.29.1.1 show access-lists interface control-plane
This command displays IP ACLs, IPv6 ACLs, and MAC access control lists information for CPU port.
Syntax
show access-lists interface control-plane
Default Setting
None
Command Mode
Privileged Exec
Display Message
ACL Type : Type of access list (IP, IPv6 or MAC).
ACL ID : Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access
list.
Sequence Number: An optional sequence number may be specified to indicate the order of this
access list relative to other access lists already assigned to this interface. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface, the specified
ccess list replaces the currently attached access list using that sequence number. If the sequence
number is not specified by the user, a sequence number that is one greater than the highest
sequence number currently in use for this interface is used. Valid range is (1 to 4294967295).

5.29.2 Configuration Commands

5.29.2.1 interface control-plane
To enter control-plane configuration mode and apply a IP, IPv6 or MAC access list to police traffic
destined for the CPU port, use the interface control-plane command in global configuration mode.
Syntax
Interface control-plane
Default Setting
No control plane access lists are defined.
Command Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 643