Quanta Computer QuantaMesh User Manual page 731

UANTA COMPUTER INC.
6.5.2.3 ip helper-address
Use this command to configure the relay of certain UDP broadcast packets received on any interface. If
the interface that receives a UDP packet has been configured with an address, this global address value
will be ignored. This command can be invoked multiple times, either to specify multiple server addresses
for a given UDP port number or to specify multiple UDP port numbers handled by a specific server.
Syntax
ip helper-address <ipaddr> { <udp-port> | dhcp | domain | isakmp | mobile-ip | nameserver |
netbios-dgm | netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time }
no ip helper-address <ipaddr> { <udp-port> | dhcp | domain | isakmp | mobile-ip | nameserver |
netbios-dgm | netbios-ns | ntp | pim-auto-rp | rip | tacacs | tftp | time }
no - This command is used to delete the address.
Default Setting
None
Command Mode
Global Config
6.5.2.4 ip helper enable
This command enable the relay of UDP packets.
Syntax
ip helper enable
no ip helper enable
no – disable the relay of UDP packets.
Default Setting
Disabled.
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 731