Quanta Computer QuantaMesh User Manual page 68

UANTA COMPUTER INC.
5.2.1.10 storm-control flowcontrol
This command enables 802.3x flow control for the switch.
802.3x flow control only applies to full-duplex mode ports. If PFC feature is enabled on the
i
same interface, 802.3x flow control will be disabled internally.
Syntax
storm-control flowcontrol
no storm-control flowcontrol
no - This command disables 802.3x flow control for the switch.
Default Setting
Disabled
Command Mode
Global Config
This command enables 802.3x flow control for the specific interface.
802.3x flow control only applies to full-duplex mode ports. If PFC feature is enabled on the
i
same interface, 802.3x flow control will be disabled internally.
Syntax
storm-control flowcontrol
no storm-control flowcontrol
no - This command disables 802.3x flow control for the specific interface.
Default Setting
Disabled
Command Mode
Interface Config
5.2.1.11 shutdown
This command is used to disable a port.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 68