Quanta Computer QuantaMesh User Manual page 869

UANTA COMPUTER INC.
7.5.2.10 ip pim dr-priority
Use this command to set the priority value for which a router is elected as the designated router (DR).
This command can be configured on a single interface or a range of interfaces.
Syntax
ip pim dr-priority <0-4294967294>
no ip pim dr-priority
no - Use this command to reset the priority value for which a router is elected as the designated
router (DR).
Default Setting
1
Command Mode
Interface Config
This command takes effect only when PIM-SM is configured as the PIM mode
i
7.5.2.11 ip pim hello-interval
Use this command to configure the PIM hello interval for the specified router interface or range of
interfaces. The hello-interval is specified in seconds and is in the range 10–18000.
Syntax
ip pim hello-interval <10–18000>
no ip pim hello-interval
no - Use this command to set the PIM hello interval to the default value.
Default Setting
30
Command Mode
Interface Config
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 869