Quanta Computer QuantaMesh User Manual page 970

UANTA COMPUTER INC.
8.4.2.35 passive-interface default
Use this command to enable global passive mode by default for all interfaces. It overrides any interface
level passive mode.OSPF shall not form adjacencies over a passive interface.
Syntax
passive-interface default
no passive-interface default
Default Setting
Disabled
Command Mode
Router OSPFv3 Config.
8.4.2.36 passive-interface
Use this command to set the interface or tunnel as passive. It overrides the global passive mode that is
currently effective on the interface or tunnel.
Syntax
passive-interface {< slot/port> | default | tunnel <tunnel-id> | vlan <vlan-id>}
no passive-interface {< slot/port> | default | tunnel <tunnel-id> | vlan <vlan-id>}
Default Setting
Disabled
Command Mode
Router OSPFv3 Config.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 970