Quanta Computer QuantaMesh User Manual page 711

UANTA COMPUTER INC.
6.3.2.33 distance ospf
distance ospf command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF route can be intra, inter, or
external. All the external type routes are given the same preference value. The range of <preference>
value is 1 to 255. no distance ospf command sets the default route preference value of OSPF routes in
the router. The type of OSPF can be intra, inter, or external. All the external type routes are given the
same preference value.
Syntax
distance ospf {intra-area <1-255> | inter-area <1-255> | external <1-255>}
no distance ospf {intra-area | inter-area | external}
Default Setting
110
Command Mode
Router OSPF Config Mode
6.3.2.34 distribute-list out
Use distribute-list out command to specify the access list to filter routes received from the source
protocol.
no distribute-list out command to specify the access list to filter routes received from the source
protocol.
Syntax
distribute-list <1-199> out {rip | bgp | static | connected}
no distribute-list <1-199> out {rip | bgp | static | connected}
Default Setting
None
Command Mode
Router OSPF Config Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 711