Quanta Computer QuantaMesh User Manual page 884

UANTA COMPUTER INC.
Default Setting
None
Command Mode
Global Config
7.6.2.11 ipv6 pim spt-threshold
This command is used to configure the Data Threshold rate for the last-hop router to switch to the
shortest path. Now support to enable (0) or disable(Infinity).
Syntax
iipv6 pim spt-threshold <0 | Infinity>
no ipv6 pim spt-threshold
<0> - This is 0 kilobits per seconds.
<Infinity> - This command will disable the function.
no - This command is used to reset the Data Threshold rate for the last-hop router to switch to the
shortest path to the default value.
Default Setting
0
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 884