Configuration Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.6.2 Configuration Commands

5.6.2.1 Logging email
This command enables email alerting and sets the lowest serverity level for which log messages are
emailed. If you specify a severity level, log messages at or above this severity level, but below the urgent
severity level, are emailed in a non-urgent manner by collecting them together until the log time expires.
You can specify the severitylevel value as either an integer from 0 to 7 or symbolically through one of the
following keywords: emergency(0), alert(1), critical(2), error(3), warning(4), notice(5), info(6), or
debug(7).
Syntax
logging email [{urgent | non-urgent} {<severity> | none}]
no logging email [{urgent | non-urgent}]
urgent - Specify the severity level for the urgent messsages. The logging messages' severity is
lower than urgent severity level will be treated as urgent message and the logging message will be
sent immediately in a single email message if the email logging is enabled.
non-urgent - Specify the severity level for the non-urgent messsages. The log messages at or
above this severity level, but below the urgent servrity level, are emailed in a non-urgent manner.
none - Do not send logging messages if urgent or non-urgent severity level is set to none.
no parameter - Indicates that to enable the logging email feature.
no - This command restore the setting to default value.
Default Setting
Email logging is disabled
Urgent severity level is alert
Non-urgent severity level is warning
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 314