Quanta Computer QuantaMesh User Manual page 257

UANTA COMPUTER INC.
5.3.13.6 show sflow source-interface
The user can go to the CLI Privilege Exec to get the configured source interface for sFlow, use the show
sflow source-interface Privilege command.
Syntax
show sflow source-interface
Default Setting
None
Command Mode
Privilege Exec
Display Message
sFlow Client Source interface: The interface ID of the physical or logical interface configured as
the sFlow client source interface.
sFlow Client Source IPv4 Address: The IP address of the interface configured as the sFlow client
source interface.
5.3.13.7 set sflow rate
The user can go to the CLI Interface Configuration Mode to set sampling rate, use the sflow rate
<0-3600> interface configuration command. Use the no sflow rate return to default value zero.
Syntax
sflow rate <0-3600>
no sflow rate
Default Setting
0
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 257