Quanta Computer QuantaMesh User Manual page 692

UANTA COMPUTER INC.
6.3.1.14 show ip ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor. The
<areaid> parameter identifies the area and the <neighbor> parameter identifies the neighbor's Router
ID.
Syntax
show ip ospf virtual-link <areaid> <neighbor>
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Area ID: The area id of the requested OSPF area.
Neighbor Router ID: The input neighbor Router ID.
Hello Interval: The configured hello interval for the OSPF virtual interface.
Dead Interval: The configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval: The configured transit delay for the OSPF virtual interface.
Retransmit Interval: The configured retransmit interval for the OSPF virtual interface.
Authentication Type: The configured authentication type of the OSPF virtual interface.
State: The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router,
and backup designated router. This is the state of the OSPF interface.
Neighbor State: The neighbor state.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 692