Quanta Computer QuantaMesh User Manual page 174

UANTA COMPUTER INC.
5.2.10.14 channel-group
This command assigns and configures an interface to a port-channel (LAG) group. The interface is a ID
of a configured port-channel.
Before adding a port to a port-channel, set the physical mode of the port. See 'speed'
i
command.
You can change the mode for an interface only if it is the only interface designated to the
specified channel group. If you enter this command on an interface that is added to a
channel with a different protocol (than the protocol you are entering), the command is
rejected.
Syntax
channel-group <ID> mode {active | on}
no channel-group <ID>
<ID> - Port-Channel Interface number. The range of the port-channel ID is 1 to 64.
active - Enables LACP unconditionally.
on - Enables static mode (Cisco EtherChannel-like).
no - Removes the interface from the specified channel group.
Default Setting
None
Command Mode
Interface Config
Command Usage
The maximum number of members for each port-channel is 32. For T1048-LB9/T1048-LB9A, the
maximum number of members is 8.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 174