Quanta Computer QuantaMesh User Manual page 547

UANTA COMPUTER INC.
5.20.2.16 match protocol
This command adds to the specified class definition a match condition based on the value of the IP
Protocol field in a packet using a single keyword notation or a numeric value notation.
Syntax
match protocol {<protocol-name> | <0-255>}
<protocol-name> is one of the supported protocol name keywords. The currently supported values
are: icmp, igmp, ip, tcp, udp. Note that a value of ip is interpreted to match all protocol number
values. To specify the match condition using a numeric value notation, the protocol number is a
standard value assigned by IANA and is interpreted as an integer from 0 to 255.
This command does not validate the protocol number value against the current list defined
i
by IANA.
Default Setting
None
Command Mode
Class-Map Config / Ipv6-Class-Map Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 547