Quanta Computer QuantaMesh User Manual page 720

UANTA COMPUTER INC.
6.3.2.50 passive-interface default
passive-interface default command to enable global passive mode by default for all interfaces. It
overrides any interface level passive mode. OSPF will not form adjacencies over a passive interface. no
passive-interface default command to disable the global passive mode by default for all interfaces. Any
interface previously configured to be passive reverts to non-passive mode.
Syntax
passive-interface default
no passive-interface default
Default Setting
Disabled
Command Mode
Router OSPF Config Mode
6.3.2.51 passive-interface
passive-interface command to set the interface or tunnel as passive. It overrides the global passive
mode that is currently effective on the interface or tunnel. no passive-interface command to set the
interface or tunnel as non-passive. It overrides the global passive mode that is currently effective on the
interface or tunnel..
Syntax
passive-interface {<slot/port> | vlan <vlan-id>}
no passive-interface {<slot/port> | vlan <vlan-id>}
Default Setting
Disabled
Command Mode
Router OSPF Config Mode
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 720