Cos (Class Of Service) Command; Show Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.23 CoS (Class of Service) Command

5.23.1 Show Commands

5.23.1.1 show queue cos-map
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the 802.1p mapping table of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
Syntax
show queue cos-map {<slot/port> | port-channel <portchannel-id>}
< slot/port > - The interface number.
<portchannel-id> - The port-channel interface number. The range of the ID is 1 to 64.
Default Setting
None
Command Mode
Privileged EXEC
User EXEC
Display Message
The following information is repeated for each user priority.
User Priority: The 802.1p user priority value.
Traffic Class: The traffic class internal queue identifier to which the user priority value is mapped.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 599