Quanta Computer QuantaMesh User Manual page 221

UANTA COMPUTER INC.
5.3.5.5 snmp-server community
This command adds (and names) a new SNMP community, and optionally sets the access mode,
allowed IP address, and create a view for the community.
Community names in the SNMP community table must be unique. If you make multiple
i
entries using the same community name, the first entry is kept and processed and all
duplicate entries are ignored.
Syntax
snmp-server community <community-string> [ipaddress <ipaddress> | ro | rw | su | view <viewname>]
no snmp-server community <community-string>
<community-string> - A name associated with the switch and with a set of SNMP managers that
manage it with a specified privileged level. The length of community-name can be up to 20
case-sensitive characters.
<ro | rw | su> - The access mode of the SNMP community, which can be public (Read-Only/RO),
private (Read-Write/RW), or Super User (SU).
<ipaddress> - The associated community SNMP packet sending address and is used along with the
client IP mask value to denote a range of IP addresses from which SNMP clients may use that
community to access the device. A value of 0.0.0.0 allows access from any IP address. Otherwise,
this value is ANDed with the mask to determine the range of allowed client IP addresses.
<viewname> - The name of the view to create or update.
no - This command removes this community name from the table. The name is the community name
to be deleted.
Default Setting
Two default community names:
‧public, with read-only permissions, a view name of Default, and allows access from all IP
addresses.
‧private, with read/write permissions, a view name of Default, and allows access from all IP
addresses.
Command Mode
Global Config
5.3.5.6 snmp-server community-group
This command configures a community access string to permit access via the SNMPv1 and SNMPv2c
protocols.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 221