Quanta Computer QuantaMesh User Manual page 660

UANTA COMPUTER INC.
6.2.1.8 show ip route entry
This command displays the router route entry information.
Syntax
show ip route entry <networkaddress>
<networkaddress> - Is a valid network address identifying the network on the specified interface.
Default Setting
None
Command Mode
Privileged Exec
Display Message
Network Address: Is a valid network address identifying the network on the specified interface.
Subnet Mask: Is a mask of the network and host portion of the IP address for the attached network.
Protocol: Tells which protocol added the specified route. The possibilities are: local, static, OSPF, or
RIP.
Total Number of Routes: The total number of routes.
for each next hop
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next destination.
Next Hop IP Address: The outgoing router IP address to use when forwarding traffic to the next
router (if any) in the path toward the destination.
Metric: Specifies the metric for this route entry.
Pref: The preference value that is used for this route entry.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 660