Service Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

5.20.4 Service Commands

The 'service' command set is used in DiffServ to define:
Traffic Conditioning Assign a DiffServ traffic conditioning policy (as specified by the policy
commands) to an interface in the incoming direction.
Service Provisioning Assign a DiffServ service provisioning policy (as specified by the policy
commands) to an interface in the outgoing direction
The service commands attach a defined policy to a directional interface. Only one policy may be
assigned at any one time to an interface in a particular direction. The policy type (in, out) must match the
interface direction to which it is attached.
This set of commands consists of service addition/removal.
The CLI command root is service-policy
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 565