Quanta Computer QuantaMesh User Manual page 201

UANTA COMPUTER INC.
5.3.1.8 ip filter
This command is used to enable the IP filter function.
Syntax
ip filter
no ip filter
no – Disable ip filter.
Default Setting
Disabled
Command Mode
Global Config
This command is used to set an IP address to be a filter.
Syntax
ip filter <name> {ipv4 | ipv6} <ipAddr> [<mask>]
no ip filter <name>
<name> - The name of the IP filter.
<ipAddr> - Configure a IP address to the filter.
<mask> - Specifies the mask for a range filter.
no - Remove this IP address from filter.
Default Setting
None
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 201