Quanta Computer QuantaMesh User Manual page 425

UANTA COMPUTER INC.
5.12.1.8 show lldp med
The user can go to the CLI Privilege Exec to display a summary of the current LLDP-MED configuration,
use the show lldp med Privilege command.
Syntax
show lldp med
Default Setting
None
Command Mode
Privileged Exec
Display Message
Fast Start Repeat Count: Specifies the number of LLDP PDUs that will be transmitted when the
protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 3.
Device Class: Specifies local device's MED Classification. There are four different kinds of devices,
three of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone
etc.]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router,
IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 425