Quanta Computer QuantaMesh User Manual page 483

UANTA COMPUTER INC.
5.16.7.3 ping ipv6 interface
This command use to determine whether another computer is on the network. To use the command,
configure the switch for network (in-band) connection. The source and target devices must have the ping
utility enabled and running on top of TCP/IP. The switch can be pinged from any IP workstation with
which the switch is connected through the default VLAN (VLAN 1), as long as there is a physical path
between the switch and the workstation. The terminal interface sends three pings to the target station.
Use the interface keyword to ping an interface by using the link-local address. You can use a loopback,
tunnel, or logical interface as the source. Use the optional size keyword to specify the size of the ping
packet.
Syntax
ping ipv6 interface {<slot/port> | serviceport | switchport | tunnel <tunnel-id>} | loopback <loopback-id>}
{<link-local-address>} [size <datagram-size>]
<slot/port> - Specify the interface.
<tunnel-id > - Specify the Tunnel ID. Range 0 -7.
<loopback-id > - Specify loopback Interface ID. Range 0 -7.
<link-local-address> - Specify link-local address.
<ipv6-address> - Specify the IPv6 address of the device.
<datagram-size> - Datagram size. Range 48 - 2048.
Default Setting
None
Command Mode
Privileged Exec
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 483