Quanta Computer QuantaMesh User Manual page 946

UANTA COMPUTER INC.
8.4.1.13 show ipv6 ospf virtual-link
This command displays the OSPF Virtual Interface information for a specific area and neighbor.
Syntax
show ip ospfv6 virtual-link <areaid> <neighbor>
<areaid> - Area ID.
<neighbor> - Neighbor's router ID.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Area ID: The area id of the requested OSPF area.
Neighbor Router ID: The input neighbor Router ID.
Hello Interval: The configured hello interval for the OSPF virtual interface.
Dead Interval: The configured dead interval for the OSPF virtual interface.
Iftransit Delay Interval: The configured transit delay for the OSPF virtual interface.
Retransmit Interval: The configured retransmit interval for the OSPF virtual interface.
Authentication Type: Shows the type of authentication the interface performs on LSAs it receives.
State: The OSPF Interface States are: down, loopback, waiting, point-to-point, designated
router, and backup designated router. This is the state of the OSPF interface.
Neighbor State: The neighbor state.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 946