Quanta Computer QuantaMesh User Manual page 62

UANTA COMPUTER INC.
5.2.1.6 interface
This command is used to enter Interface configuration mode.
Syntax
interface {<slot/port> | loopback <loopback-id> | port-channel <portchannel-id> | tunnel <tunnel-d> |
vlan <vlan-id>}
<slot/port> - is the desired interface number.
<loopback-id> - is the desired loopback interface number. The range of loopback ID is 0 to 7.
<portchannel-id> - is the desired port-channel interface number. The range of port-channel ID is 1
to 64.
<tunnel-id> - is the desired tunnel interface number. The range of tunnel ID is 0 to 7.
<vlan-id> - is the desired vlan interface number. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 62