Quanta Computer QuantaMesh User Manual page 392

UANTA COMPUTER INC.
5.9.7.2.7 dos-control udpport
This command enables the UDP L4 source = destination port number (Source UDP Port = Destination
UDP Port) Denial of Service protection. If the mode is enabled, Denial of Service prevention is active for
this type of attack. If packets ingress with Source UDP Port =Destination UDP Port, the packets will be
dropped if the mode is enabled.
Syntax
dos-control udpport
no dos-control udpport
no - This command disables the UDP L4 source = destination port number (Source UDP Port
=Destination UDP Port) Denial of Service protection.
Default Setting
Disabled
Command Mode
Global Config
5.9.7.2.8 dos-control icmpv4
This command enables Maximum ICMPv4 Payload Size Denial of Service protections. If the mode is
enabled, Denial of Service prevention is active for this type of attack. If ICMP Echo Request (PING)
packets ingress having a payload size greater than the configured value, the packets will be dropped if
the mode is enabled.
Syntax
dos-control icmpv4
no dos-control icmpv4
no - This command disables Maximum ICMPv4 Payload Size Denial of Service protections.
Default Setting
Disabled
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 392