Quanta Computer QuantaMesh User Manual page 166

UANTA COMPUTER INC.
5.2.10.6 port-channel load-balance
This command for CLI will configured the mode of load balance on the all Port Channels. The parameter
src-mac | dst-mac | dst-src-mac | src-ip | dst-ip | dst-src-ip | enhanced
"
used to be set for port-channel load balance.
Syntax
port-channel load-balance { src-mac | dst-mac | dst-src-mac | src-ip | dst-ip | dst-src-ip | enhanced}
{<ID> | all}
no port-channel load-balance {<ID> | all}
src-mac - Sets the mode on the source MAC address.
dst-mac - Sets the mode on the destination MAC address.
dst-src-mac - Sets the mode on the source and destination MAC addresses.
src-ip - Sets the mode on the source IP address.
dst-ip - Sets the mode on the destination IP address.
dst-src-ip - Sets the mode on the source and destination IP addresses.
enhanced - Set the mode on the source and destination MAC addresses if it is a L2 packet or on the
source and destination IP addresses if it is a IP packet.
<ID> - The ID of the port-channel to be configured.
no - Restore the mode to be default value.
Default Setting
dst-src-ip
Command Mode
Global Config
Layer 2/3/4 Managed Switch
" represent the mode
QuantaMesh | Switching Commands 166