Quanta Computer QuantaMesh User Manual page 922

UANTA COMPUTER INC.
8.3.2.7 ipv6 route distance
This command sets the default distance (preference) for IPv6 static routes. Lower route distance values
are preferred when determining the best route. The ipv6 route command allows you to optionally set the
distance (preference) of an individual static route. The default distance is used when no distance is
specified in this command.
Changing the default distance does not update the distance of existing static routes, even if they were
assigned the original default distance. The new default distance will only be applied to static routes
created after invoking the ipv6 route distance command.
Syntax
ipv6 route distance <1-255>
no ipv6 route distance
no – This command resets the default static route preference value in the router to the original
default preference. Lower routepreference values are preferred when determining the best route.
Default Setting
1
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 922