Quanta Computer QuantaMesh User Manual page 879

UANTA COMPUTER INC.
7.6.2.3 ipv6 pim
This command administratively enables PIM on an interface or range of interfaces.
Syntax
ipv6 pim
no ipv6 pim
no - This command sets the administrative mode of PIM on an interface to disabled.
Default Setting
Disbaled
Command Mode
Interface Config
7.6.2.4 ipv6 pim hello-interval
Use this command to configure the PIM hello interval for the specified router interface or range of
interfaces. The hello-interval is specified in seconds and is in the range 0–18000.
Syntax
ipv6 pim hello-interval <0–18000>
no ipv6 pim hello-interval
no - Use this command to set the PIM hello interval to the default value.
Default Setting
30
Command Mode
Interface Config
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 879