Quanta Computer QuantaMesh User Manual page 256

UANTA COMPUTER INC.
5.3.13.5 show sflow rate
Use this command to display the sFlow traffic rate summary on the switch.
Syntax
show sflow rate interface [<slot/port>]
<slot/port> - An interface number.
no parameter - All interfaces.
Command Mode
Privilege Exec
Display Message
Octets Received
Rate
Unicast Packets
Received Rate
Multicast Packets
Received Rate
Broadcast Packets
Received Rate
Discarded Packets
Received Rate
Errors Received
Rate
Unknown
Protocols Packets
Received Rate
Octets
Transmitted Rate
Unicast Packets
Transmitted Rate
Multicast Packets
Transmitted Rate
Broadcast Packets
Transmitted Rate
The number of octets rate received on the interface including framing
characters.
The number of unicast packets rate delivered by this sub-layer to a higher
sub-layer.
The number of multicast packets rate delivered by this sub-layer to a higher
sub-layer.
The number of broadcast packets rate delivered by this sub-layer to a higher
sub-layer.
The number of inbound packets rate which were chosen to be discarded.
The number of the counter rate IfInErrors.
The number of packets rate received via the interface which were discarded
because of an unknown or unsupported protocol.
The total number of octets rate transmitted out of the interface, including
framing characters.
The total number of unicast packets rate that higher-level protocols requested
be transmitted.
The total number of multicast packets rate that higher-level protocols
requested be transmitted.
The total number of broadcast packets rate that higher-level protocols
requested be transmitted.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 256