Quanta Computer QuantaMesh User Manual page 905

UANTA COMPUTER INC.
8.3.1.2 show ipv6 interface port
This command displays the usability status of IPv6 interfaces and whether ICMPv6 Destination
Unreachable messages may be sent.
Syntax
show ipv6 interface [{ brief | {port <slot/port> | vlan <vlan-id>} [prefix] }]
<slot/port> - Valid slot and port number separated by forward slashes.
<vlan-id> - VLAN ID. The range of VLAN ID is 1 to 4093.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Message
If you use the brief parameter, the following information displays for all configured IPv6 interfaces:
Interface: Shows the interface in slot/port format.
IPv6 Routing Operational Mode: Shows whether the mode is enabled or disabled.
IPv6 Address/Length: Shows the IPv6 address and length on interfaces with IPv6 enabled.
If you specify an interface, the following information also appears.
Routing Mode: Shows whether IPv6 routing is enabled or disabled.
IPv6 Routing Operational Mode: Shows whether the operational state of an interface is enabled or
disabled.
Bandwidth: Shows the bandwidth of the interface.
Interface Maximum Transmission Unit: Shows the MTU size, in bytes.
Router Duplicate Address Detection Transmits: Shows the number of consecutive duplicate
address detection probes to transmit.
Router Advertisement NS Interval: Shows the interval, in milliseconds, between router
advertisements for advertised neighbor solicitations.
Router Lifetime Interval: Shows the router lifetime value of the interface in router advertisements
Router Advertisement Reachable Time: Shows the amount of time, in milliseconds, to consider a
neighbor reachable after neighbor discovery confirmation.
Router Advertisement Interval: Shows the frequency, in seconds, that router advertisements are
sent.
Router Advertisement Managed Config Flag: Shows whether the managed configuration flag is
set (enabled) for router advertisements on this interface.
Layer 2/3/4 Managed Switch
QuantaMesh | IPv6 Commands 905