Quanta Computer QuantaMesh User Manual page 329

UANTA COMPUTER INC.
5.8.2.4 username snmpv3 encryption
This command specifies the encryption protocol and key to be used for the specified login user. The
valid encryption protocols are none or des. The des protocol requires a key, which can be specified on
the command line. The key may be up to 16 characters. If the des protocol is specified but a key is not
provided, the user will be prompted to enter the key. If none is specified, a key must not be provided.
The <username> is the login user name for which the specified encryption protocol will be used.
Syntax
username snmpv3 encryption <username> {none | des [<key>]}
no username snmpv3 encryption <username>
<username> - is the login user name.
des - des encryption protocol.
none - no encryption protocol.
<key> - A key 128 alphanumeric characters in length.
no - This command sets the encryption protocol to none. The <username> is the login user name for
which the specified encryption protocol will be used.
Default Setting
No encryption
Command Mode
Global Config
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 329