Quanta Computer QuantaMesh User Manual page 796

UANTA COMPUTER INC.
6.11.1.13 show ip bgp update-group
This command displays information about the Border Gateway Protocol (BGP) update groups.
Syntax
show ip bgp update-group [index-group | peeripadd]
index-group - Update group type with its corresponding index number. The range of update-group
index numbers is from 1 to 4294967295.
peeripadd - IP address of a single neighbor who is a member of an update group.
Default Setting
None
Command Mode
Privileged Exec
User Exec
Display Messages
Update Group: Update-group number.
Peer Type: Update-group type (internal or external).
Minimum Advertisement Interval: Minimum time, in seconds, between update advertisements.
Neighbor AS Path Access List Out: Neighbor AS Path list out. All members of the group use the
same.
Neighbor Prefix List Out: Neighbor prefix list out. All members of the group use the same.
Neighbor Route Map Out: Neighbor route map out. All members of the group use the same.
Members Added: Number of members added to the group.
Members Removed: Number of members removed from the group.
Update Version: Number of times phase 3 of the decision process has run for the group.
Number of UPDATES Sent: Number of UPDATE packets sent to this group.
Time Since Last UPDATE: Number of seconds since last UPDATE sent to group.
Current Prefixes: Number of prefixes currently advertised to the group.
Current Paths: Number of paths in update group's Adj-RIB-Out.
Prefixes Advertised: Number of prefixes advertised.
Prefixes Withdrawn: Number of prefixes withdrawn.
UPDATE Send Failures: Tx of UPDATE message failed to one or more group members.
Current Members: Number of member listed by IP address in the update group.
Version: The number of times decision process phase 3 had run before this history table entry.
Delta T: When update send occured.
Layer 2/3/4 Managed Switch
QuantaMesh | Routing Commands 796