Quanta Computer QuantaMesh User Manual page 377

UANTA COMPUTER INC.
5.9.4.10 radius server msgauth
This command enables the message authenticator attribute for a specified server.
Syntax
radius server msgauth <ipaddr| ipv6addr| hostname >
<ipaddr| ipv6addr| hostname > - is a IPv4/v6 address or hostname.
Default Setting
None
Command Mode
Global Config
5.9.4.11 radius server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS client.
The primary server is the one that is used by default for handling RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. A maximum of three servers
can be configured on each client. Only one of these servers can be configured as the primary. If a
primary server is already configured prior to this command being executed, the server specified by the IP
address specified used in this command will become the new primary server. The IP address must
match that of a previously configured RADIUS authentication server.
Syntax
radius server primary <ipaddr| ipv6addr| hostname>
<ipaddr | ipv6addr | hostname > - is a IPv4/v6 address or a hostname.
Default Setting
None
Command Mode
Global Config
5.9.4.12 radius source-interface
Use this command to specify the physical or logical interface to use as the RADIUS client source
interface (Source IP address). If configured, the address of source interface is used for all RADIUS
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 377