Quanta Computer QuantaMesh User Manual page 537

UANTA COMPUTER INC.
5.20.2.4 match any
This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class.
Syntax
match any
Default Setting
None
Command Mode
Class-Map Config / Ipv6-Class-Map Config
5.20.2.5 match class-map
This command adds to the specified class definition the set of match conditions defined for another
class.
Syntax
match class-map <refclassname>
<refclassname> is the name of an existing DiffServ class whose match conditions are being
referenced by the specified class definition.
There is no [not] option for this match command.
i
Default Setting
None
Command Mode
Class-Map Config / Ipv6-Class-Map Config
Restrictions The class types of both <classname> and <refclassname> must be identical (that is, any
vs. any, or all vs. all). A class type of acl is not supported by this command.
Cannot specify <refclassname> the same as <classname> (that is, self-referencing of class name not
allowed). At most one other class may be referenced by a class. Any attempt to delete the
<refclassname> class while still referenced by any <classname> shall fail.
Layer 2/3/4 Managed Switch
QuantaMesh | Switching Commands 537