Ipv4 Protocol Independent Multicast (Pim) Commands; Show Commands - Quanta Computer QuantaMesh User Manual

UANTA COMPUTER INC.

7.5 IPv4 Protocol Independent Multicast (PIM) Commands

7.5.1 Show Commands

7.5.1.1 show ip pim
This command displays the system-wide information for PIM-DM or PIM-SM.
Syntax
show ip pim
Default Setting
None
Command Mode
Privileged Exec, User Exec
Display Message
PIM Mode: Indicates whether the PIM mode is dense (PIM-DM) or sparse (PIM-SM)
Data Threshold: Rate (in kbps) of SPT Threshold
Register Rate-limit: Rate (in kbps) of the Register Threshold
Interface: slot/port
Interface Mode: Indicates whether PIM is enabled or disabled on this interface
Operational Status: The current state of PIM on this interface: Operational or Non-Operational.
Layer 2/3/4 Managed Switch
QuantaMesh | IP Multicast Commands 856